Fujitsu FI-4860C2 Operator's Manual page 257

5) At <Screen25-3>, you can specify if the numbering should be initialized to the
specified initial value in 4) at hopper empty.
To specify to initialize the numbering counter at hopper empty, press
arrow button) and select [On].
Press (Enter button) to confirm the selection. Then, <Screen25-4> is
displayed.
To specify not to initialize the counter at hopper empty but continue
incrementing, select [Off], press
is displayed.
6) At <Screen25-4>, specify if the numbering counter should be initialized
immediately to the vlaue specified in 4).
To specify to initialize immediately, press
[Yes].
To specify not to initialize immediately, select [No] and press
button).
7) Press (Enter button) to confirm the setting.
Press (Exit button), and the LCD display goes back to [Ready] screen.
Command from the PC takes the priority over the setting from the Operator
ATTENTION
panel.
(Enter button) and then <Screen 25-4>
<Screen25-4>
! 2 5 -
4
=
R e s e t N
N o / Y e
(Right arrow button) and select
7.3 Setup Mode Details
(Left
7
o w
s
(Enter
7-57