Advertisement
Installing HP 16442A Test Fixture
You can make the HP 16442A stable by installing stabilizers as shown in the following figure.
1. Put a stabilizer on both sides of test fixture.
2. Screw a flathead screw into hole of each stabilizer.
After installing stabilizers, connect terminals on the rear panel to the desired measurement
units.
When you attach HP 16442A to HP 16440A SMU/Pulse Generator Selector
Note
or HP 16441A R-Box, you do not need to install stabilizers. For attaching to
selector or R-Box procedure, see the User's Guide for selector or R-Box.
HP 16442A User's Gude 3
Advertisement
