Table of Contents
Advertisement
Installation
(In existing construction)
IV
Installing the ventilating fan in an existing construction
requires an accessible area (attic or crawl space) above
the planned location or existing ducting and wiring.
CAUTION:
Check area above planned installation location to be
sure that:
1.
Duct work can be installed and that area is sufficient
for proper ventilation.
2.
Wiring can be run to planned location.
3.
No wiring or other obstructions will interfere with
installation.
Maintenance (Replacement of fluorescent lamp or night lamp)
WARNING:
1. Disconnect power source before working on unit.
2.
The lamp's glass is fragile. Please handle with
care. To remove lamp, grasp at base and move
back and force to loosen.
Do not pull hard on the lamp or you may break the
glass.
3.
4W night lamp has threaded base. Remove by
turning counterclockwise.
1. Remove grille. (Squeeze mounting spring and pull down)
Gloves
Grille
I
Slot
Mounting spring
1.
To install the ventilating fan, follow the procedures
described in Installation I.
2.
Inspect duct work and wiring before proceeding
with installation.
3.
Plan suitable location for ventilating fan. (next to
ceiling joist).
Before installation, provide inspection and maint-
4.
enance access at a location that will not interfere
with installation work shown in Installation I.
5.
Remove ceiling section according to Fig. 4 on
page 6.
Install ventilating fan.
6.
2. Disconnect the connector II or connector III of light
unit.
Change the fluorescent bulbs (Panasonic FDS 13E
3.
(Fig. 28)
27.U/2, 13W or FQ13E 41.U/2, 13W or FQ13E 35.U/2,
13W) or the 4W incandescent lamp, connect the connector
II or connector III and replace the grille.
Fig. 28
14
(Fig. 29)
Connector
II
Connector
III
Fig. 29
(Fig. 30)
Fig. 30
Hide quick links:
Advertisement
Table of Contents
