Panasonic FV-08VQL3 Installation Instructions Manual page 5

Installation (Joist mounting installation)
I
CAUTION:
Remove the bracket cover by loosening 4 (M4x6)
screws before installation
1.
Disconnect plug connector from receptacle before
starting installation.
2.
Remove adapter from body and fix to ceiling joists
using long screws (M4X30). Slide the installation bracket
* into slot next to the junction box. If longer extension
is needed, assemble brackets * and * as shown below.
Secure the angular end of the bracket to the ceiling
joist. (See Fig.2.) Make sure the adapter is level and
square (perpendicular) with the joists.
Keep the distance B (21.6mm,0.85 inch) for the thickness
of ceiling board.
Installation bracket II
3. Remove junction box cover and secure conduit to
junction box knockout hole.(7/8 inch)
4.
Refer to wiring diagram.
Using wire nuts, connect house power wires to ventilating
fan wires:
black to blacks; white to whites; green to greens.
Replace junction box cover.
(Fig.1)
(Fig.1)
(Fig.2)
Installation
bracket I
Screw I
(M4x6)
(Fig.3)
(Fig.3)
Receptacle
Fan body
Installation
bracket
Ceiling joist
Junction box
Lead wires
Separate connection
5
Plug connector
Bracket cover
Screw driver
Fig. 1
Screw
Adapter
Long screw
Junction box
Ceiling joist
Ceiling joist
B
Fig. 2
Duct
Junction box cover
Conduit
Green wires
Lump-sum connection
Fig. 3
Wire nut