Table of Contents
Advertisement
Installation
(Wooden header installaton)
II
1.
Before installation, secure adapter to fan body using
two thumb screws.
2.
Insert the plug connector II and plug connector III into the
receptacle II and receptacle III respectively. Install the light
unit to the fan body by using plastic screws (M4x13)
and one short screw I (M4x12). Insert the fluorescent
lamps and screw the night lamp into the light unit.
3.
Install header between ceiling joists using nails or screws.
Secure the Fan/Light assembly to the header with long
4.
screws (M4X30).
5.
Slide the 4" circular duct onto the adapter and secure
with tape. Remove the junction box cover and secure
conduit to junction box knockout hole. (7/8 inch)
6.
Refer to wiring diagram.
Using wire nuts, connect house power wires to ventilating
fan wires:
black to blacks; white to whites; green to greens.
Replace junction box cover.
CAUTION:
Mount junction box cover carefully so that lead wires
are not caught.
Wiring Diagram
Fan unit
Red
Black
Capacitor
Black
Motor
White
Green
Night Lamp
7.
Finish ceiling work. Ceiling hole should be cut at the
edge of the flange.
8.
Insert the lamp cover into the Grille and attach the grille
to the fan unit.
When connecting the light unit and fan unit seperately, read the note on page 6 before making connections.
(Fig.10, Fig. 12)
(Fig. 14)
(Fig. 14)
Light unit
Lamp
Lamp
Ballast
Ballast
Power supply
AC 120V 60 Hz
Green
Earth ground
Junction box
Black
Power Supply
White
AC120V 60Hz
(Fig. 11)
(Fig. 12)
(Fig. 13)
Ceiling joist
Ventilating fan
mm(inch)
(Fig. 3)
(Fig. 15)
Ceiling
9
Light unit
Thumb screws
Fan body
Header
Adapter
Adapter
Long screws
Flange
Fig. 12
Ceiling joist
Fig. 13
Circular duct
Junction box cover
Fig. 14
Fig. 15
Hide quick links:
Advertisement
Table of Contents
