Table of Contents
Advertisement
1-7. Rack Mounting
1-7-1. DMW-S01NL/DMW-S02NL
The main unit (workstation with AV I/O block) of DMWS01NL/
DMW-S02NL is able to mount in the 19-inch standard rack.
To mount the DMW-S01NL/DMW-S02NL in the rack, use
the specified rack mount kit and follow the procedure
described below.
Required parts
. Specified rack mount kit
. Rack cover
. Rack plate
. Rack plate attaching screws : 4 pcs (Supplied with DMW-S01NL/
(B4 x 8 : 7-682-561-09)
. Unit attaching screws*
(10-32 UNF x 1/2)
* This screws are not supplied with DMW-S01NL/DMW-
S02NL.
n
If a rack mount kit other than the specified one is used, the
unit may not be mounted in the 19-inch standard rack.
Parts of the RMM-10
. Rack brackets
. Right rack mount adapter
[Including two screws (B4 x 6 : 7-682-560-09)]
. Left rack mount adapter
[Including two screws (B4 x 6 : 7-682-560-09)]
. Rack brackets and adapter attaching screws : 6 pcs
(B4 x 6 : 7-682-560-09)
. Adapter attaching screws
(B4 x 10 : 7-682-560-10)
1-24
: Sony RMM-10 (Optional accessory)
: 2 pcs (Supplied with DMW-S01NL/
DMW-S02NL)
: 2 pcs (Supplied with DMW-S01NL/
DMW-S02NL)
DMW-S02NL)
: 4 pcs
: 2 pcs
: 1 pc
: 1 pc
: 6 pcs
. . . . . Rack mounting procedure
This section describes the rack mounting procedure using
the RMM-10 rack mount kit.
n
Tighten the screws to the following torque.
Tightening torque : 120 x 10
(1) Remove six screws and remove the feet from the
bottom of the unit.
(2) Attach the rack brackets to the side of the unit using
the specified six screws.
n
Use B4 x 6 screws. Using other screws may cause
problems in the operations of the unit.
(3) Attach the rack plate to the side of the equipment using
the specified four screws.
n
Use B4 x 8 screws. Using other screws may cause
problems in the operations of the unit.
Rack brackets
B4 x 6
Rack plates
B4 x 8
Feet
PSW4 x 20
_2
N.m {12.2 kgf.cm}
B4 x 6
B4 x 8
DMW-S01NL/S02NL/ST001
Advertisement
Table of Contents
