Table of Contents
Advertisement
2-1. Digital media workstation/A/V block
2-1-2. Removal of AV I/O Block
(1) Remove the three screws (+B4 x 6) of the rear panel.
+B4 x 6
(2) Slide the AV I/O block toward backward in the arrow
direction on the figure.
AV I/O block
(3) Turn the AV I/O block to right side, which take the front view
of the unit in the arrow direction on the figure, then remove it.
m
. When removing or replacing the unit, be sure to
maintaining the space in full for performing it.
. When sliding the AVI/O block toward backward, it is
required to heavy physical force. Therefore, make sure to
working it more than two persons.
. When removing the AV I/O block, be careful not to pull
the two connected cables as well as not to damage them.
2-2
2-1-3. Replacement of Main Parts
1. Digital Media Workstation
a) Power Module
(1) Slide the AV I/O block toward backward.
(Refer to "Sec. 2-1-2".)
(2) Remove the four screws (+B4 x 6).
(3) Release the two claws to pull the front mask in front
side while lifting up the following A and B portions on
the figure.
(4) Release the two claws to pull the front mask in front
side while pulling down the following C and D
portions on the figure.
(5) After confirming that these claws was released,
remove the front mask (PC).
+B4 x 6
A
B
C
Front mask (PC)
D
Switch cap
n
When removing the front mask (PC), the switch cap comes
out from the power switch in some cases.
In this case, be sure to insert the switch cap correct direc-
tion to the power switch as shown in the figure.
(Set the stamp number on the flange facing in back and the
flash side to the right side direction.)
+B4 x 6
Power
Stamp
switch
number
Flash
Flange
DMW-S01NL/S02NL/ST001
Advertisement
Table of Contents
