Table of Contents
Advertisement
2. Fader Panel (Lower) Assembly
(1) Remove the fader panel (upper) assembly, then
remove one harness and two flat cables from the
CPU-315 board. (Refer to steps (1) through (3) in
section 2-2-2-1.)
(2) Remove four screws (PSW3 x 6) and remove the
shield plate (upper).
(3) Remove two screws (B3 x 6) and remove the
CPU-315 board assembly from the fader panel (lower)
assembly.
*
DMW-S01NL/S02NL/ST001
http://getMANUAL.com
PSW3 x 6
Shield plate
(upper)
*
CPU-315 board
assembly
B3 x 6
Fader panel
(lower) assembly
2-2-3. Replacement of Main Parts
1. Replacement of Fader
(1) Remove the SV-220 board assembly. (Refer to steps
(1) through (5) in section 2-2-2-1.)
(2) Peel the fader sheet from the fader bracket to remove
it.
(3) Remove eighteen screws (B3 x 4), then remove the
fader bracket.
(4) Unsolder eight soldered joints, remove the replaced
fader from the SV-220 board.
Fader
(5) Install the fader in the reverse order of steps (1)
through (4).
. Setting and adjustment are no necessity after replace-
ment of fader.
2-2. Audio Control Panel
Fader sheet
B3 x 4
SV-220
board
assembly
Fader
bracket
SV-220
board
2-21
Advertisement
Table of Contents
