Beko BEKOKAT CC-360 Installation And Operation Manual page 79

DANGER Electric power
Touchable conductive parts can lead to dangerous voltages / mains
voltage during installation and maintenance or in case of defects. Hazard
resulting in of serious or even fatal injury from electric shock when coming
into contact with uninsulated parts or mains voltage.










V01 /11-046
All work on the electrical components of the BEKOKAT
carried out by suitably trained specialists.
Before starting work, disconnect the system from the power supply
via an external disconnecting device.
®
The BEKOKAT must not be put into operation if the power supply
cables have been damaged or parts of the housing have been
damaged or removed.
The valid legal regulations and provisions at the local place of use
must be complied with without exception.
Observe the electrical data provided on the rating plate.
Work on the electrical connections may only be executed when the
power supply is switched off. The system must be secured against
unintentional restart.
Only utilise components for the electrical installation which have a
current authorisation and are labelled with a CE-Identification
marking.
The wire ends to be connected to the control unit must be equipped
with wire-end ferrules.
All electrical connections must be inspected before commissioning
and at regular intervals.
The removal of seals and labels on safety equipment is prohibited.
Installation and Operation Manual BEKOKAT
®
®
may only be
79 / 88