Toro Groundsmaste 3200 Series Installation Instructions Manual page 2

2
Installing the Clips, Speed
Nuts, and Fuse Block
Parts needed for this procedure:
1 Switch mount
6 Clip (1/4 inch)
2 Speed nut
1 Fuse mount plate
4 U-type speed nut
1 Fuse block
2 Screw (#10 x 3/4 inch)
Procedure
1. Install the 6 clips and 2 speed nuts to the switch
mount (Figure 1).
1. Clip
2. Switch mount
Figure 1
3. Speed nut
2. Install the U-type speed nuts to the fuse-mount
plate (Figure
1. U-type speed nuts
3. Install the fuse block on the wire harness to the
fuse-mount plate using 2 screws (#10 x 3/4 inch)
as shown in
g319851
1. Fuse-mount plate
2. Fuse block
2
2).
Figure 2
2. Fuse-mount plate
Figure 3.
Figure 3
3. Screw (#10 x 3/4 inch)
g304335
g304300