Toro Groundsmaste 3200 Series Installation Instructions Manual page 6

9. Raise the base up and drill a 22 mm (7/8 inch)
hole as shown in
1. Steering-column base
10. Route the harness through the hole you drilled
in the base.
11. Leave the bullet connectors disconnected as
shown in Figure
1. Leave the bullet connectors disconnected.
Figure 9.
Figure 9
10.
Figure 10
12. Apply the decal to the fuse cover as shown in
Figure 11.
g304296
1. 25 mm (1 inch)
2. 6 mm (1/4 inch)
13. Install the fuse cover to the switch mount using
2 thumb screws and 2 push nuts
Note:
Ensure that the push nuts are installed
on the inside of the fuse cover
g333871
1. Push nut
2. Fuse cover
6
Figure 11
3. Decal—inside of fuse
cover
(Figure
(Figure
Figure 12
3. Thumb screw
g304374
12).
12).
g304295