Toro Groundsmaste 3200 Series Installation Instructions Manual page 7

14. Adjust the control assembly so that the switches
are accessible.
15. Tighten all the fasteners.
16. Install the control cover to the switch mount
using 2 push rivets and 6 hex-head screws (1/4
x 3/4 inch) as shown in
Figure 13
1. Push rivet
2. Hex-head screw
Figure 13.
g319852
3. Control cover
4
Installing the Front
Components
Parts needed for this procedure:
1 Left light base (for machines with a cab)
1 Right light base (for machines with a cab)
1 Left light mount
1 Right light mount
1 Left light assembly
1 Right light assembly
6 Button-head bolt (1/4 x 5/8 inch)
4 Carriage bolt (3/8 x 3/4 inch)—for machines with a cab
4 Locknut (3/8 inch)—for machines with a cab
1 Light cross mount (for machines without a cab)
For Machines with a Cab
When installing the light mounts, refer to the following
chart for the mounting position based on your mower
deck size and type.
Light Position Table
Cutting
Unit Model Front Lights
Number
31970 Narrow
31971 Narrow
31972 Wide
31973 Narrow
31974 Narrow
31975 Narrow
7
Rear, Left Rear, Right
Light Light
Narrow Wide
Narrow Narrow
Narrow Wide
Narrow Narrow
Narrow Narrow
Narrow Narrow