Installing The Outdoor Unit - Huawei NetCol8000-A045D Quick Manual

3.5
Lowering a Fan (Applicable to Downflow Units)
1. Remove the six screws
and then the beam.
4

Installing the Outdoor Unit

• Before installing the outdoor unit, keep the protective paperboard for the fins at the bottom
to protect people from injuries during the installation. Remove it after installation.
• The installation methods and distance requirements for installing NetCol500-A060,
NetCol500-A080, and NetCol500-A120 outdoor units are the same. This section describes
how to install a NetCol500-A060. The NetCol500-A110 outdoor unit does not support vertical
installation.
• If the space does not meet the requirements of the recommended layout, you can use any of
the layouts (applicable only to NetCol500-A060) in the user manual.
2. Rotate the fan upward by 30 degrees, and
pull the rotating shaft of the fan to the
outermost side.
3. Slowly rotate the fan by 90 degrees and ensure
that the rotating shaft of the fan is on the
outermost side. Exercise caution when handling
the fan to avoid body injury.
4. After the fan rotates to the position shown in the
figure, push the fan back to the horizontal position.
5. Tighten the six screws on the beam and fan
support, and connect the fan cables using the
interconnection terminal reserved in the cabinet.
7