Working With The Continuous Shredder - Silvercrest SKM 550 B2 Operating Instructions Manual

NOTE
► While kneading and/or mixing, please note
that the dough in the mixing bowl 6 will in-
crease in volume or will be pressed upwards
by the tool. Take note of the table in the sec-
tion "Recommended filling quantities".
6) Press down the release button e and move
the pivoting arm t down into operating
position 1 (Image A).
7) Slide the lid onto the mixing bowl 6 so that the
catches on the pivoting arm t click into place.
8) Turn the rotary switch r to the required setting
(Image B).
Refilling with ingredients
■ Add the ingredients through the hole in the lid
during operation.
Or:
1) Switch the appliance off using the rotary
switch r.
2) Remove the lid.
3) Press down the release button e and move
the pivoting arm t into operating position 5.
4) Add the ingredients.
■ 26 │ GB │ IE
After you have finished
using your appliance
1) Switch the appliance off using the rotary
switch r.
2) Remove the lid.
3) Press down the release button e and move
the pivot arm t into operating position 4.
4) Remove the attachment you have been using
from the drive unit z.
5) Remove the mixing bowl 6.
6) Clean the appliance (see section "Cleaning
and care").
Working with
the continuous shredder
WARNING! RISK OF INJURY!
► To avoid personal injury and damage to the
appliance, never insert or place your hands
or any foreign objects into the feed tube.
► Always use the pusher and no other implement
or body part to push ingredients into the
appliance. Danger of injury due to rotating
parts!
► Switch from one accessory to another only
when the drive unit z is at a complete stand-
still! After being switched off, the drive unit z
will continue to run for a short time.
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket.
This will prevent the appliance from becoming
switched on again unintentionally.
NOTE
► The appliance may only be used when the
drive hubs not being utilised are fitted with
their protective covers.
Make sure that neither the kneading hooks 1,
►
the whisk 2, or the beater 3 are attached
to the pivot arm t.
SKM 550 B2