Fujitsu 5GRUDB3 User Manual page 107

107
Installation
RU Installation
Flat Washer
Split Washer
Lag Bolt
Figure 23
Attaching Wall Mount Plate to Wall Surface
Step 2
Torque each of the four bolts to 27 Nm.
Step 3
Place large insulating bushings on the wall plate by performing the following substeps:
a) Peel the adhesive covering off of the large insulating bushings.
b) Align the sticky side of the bushings with the threaded holes on the lower front lip of the wall plate and stick
them in place as shown in the following graphic.
Fujitsu and Fujitsu Customer Use Only
·
Issue 1.1, May 2021
Release 1.0