Fujitsu 5GRUDB3 User Manual page 109

Installation
RU Installation
Lag Bolt
Figure 25
Attaching Radio to Wall Mount Plate
Step 5
Secure the RU in place using M10 bolts by performing the following substeps:
a) Loosely screw two M10 x 30 bolts into the holes on the top of the RU with flat and split washers used for
spacing.
b) Loosely screw two M10 x 40 bolts into the holes on the lower front of the RU with an insulating stepped
bushing and flat and split washers used for spacing. Ensure the shoulder of the stepped bushing is perfectly fit
inside of the hole on the L-bracket for proper alignment.
·
Issue 1.1, May 2021
Release 1.0
Lag Bolt
Insulating Bushing
Insulating Bushing
Bolt (M10x30)
Split Washer
Flat Washer
Flat Washer
Bolt (M10x40)
Split Washer
109
Fujitsu and Fujitsu Customer Use Only