Rear Panel Removal - Panasonic AJ-SD93P/E Service Manual

3. Unscrew the four screws (F) and (G), and then
slowly lift up the Front Loading Unit.
(G)

1-5. Rear Panel Removal

1. Unscrew the 2 screws (H) and remove the Boards
support plate.
2. Unscrew the 4 screws (I).
(I)
3. When the Optional Board (SDI Board) AJ-YA94G is
installed, remove the SDI Board as shown below.
SDI Board (AJ-YA94G)
4. When the Optional Boards (IVIO Board and OPT
JACK Unit) is installed, unscrew the 4 screws (J).
(G)
(F)
(H)
5. Pulling back the OPTJACK Board Unit and remove
it.
Note: The OPTJACK has been connected with the
MOTHER board by connectors as shown below.
6. Unscrew the 5 screws (K) and (L)
(K)
7. Unscrew the 2 screws (M) and remove the Rear
Panel.
Rear Panel
DIS-2
(J)
(J)
Connectors
OPTJACK
Board Unit
(AJ-YA63)
(L)
(K)
(M)