Siemens RUGGEDCOM RX1501 Installation Manual page 50

3. Pull the module from the chassis to disconnect it.
Figure 4.2
4. Install a new module or a blank module (to prevent the ingress of dust and dirt).
5. [Optional] If necessary, install the device in the rack.
Installing a Module
To install a line module, do the following:
1. [Optional] If the device is installed in a rack, remove it from the rack.
2. Remove the current module from the slot.
3. Insert the new module into the slot.
Figure 4.3
4. Tighten the screws to secure the module.
5. [Optional] If necessary, install the device in the rack.
RUGGEDCOM RX1501
Installation Manual, 05/2020, C79000-G8976-1054-17
All manuals and user guides at all-guides.com
1
2
3
Module
1
Chassis
2
Screw
3
Removing a Module
1
2
3
Module
1
Chassis
2
Screw
3
Installing a Module
4.3 Installing/Removing Line Modules
Modules
41