Switch Setting; Station Address Setting Switches (Stn-H, Stn-L) - Toshiba V Series User Manual

Chapter 3 Settings

3.1 Switch Setting

3.1.1

Station address setting switches (STN-H, STN-L)

3
6
Set the switches for selecting an operation mode and a station address before switching
the AN712 module on. These switches are on the front panel of the AN712 module.
The switch setting procedures are described below.
STN-H and STN-L are hexadecimal rotary switches used to select an ADMAP node
address. Set a station address in the range of 1 to 127 allocated to the system during the
process of its building, using HEX (hexadecimal) code. Allocate an address different from
others in value to each of the nodes in the system.
Use a small screwdriver for setting them.
Table 3-1 Station Address Setting
Name
Setting range: 01 to 7F (h)
STN-H STN-H (Upper digit address) 0 to 7 (h)
STN-L STN-L (Lower digit address): 0 to F (h)
Note: (h) means hexadecimal code.
STN-H
STN-L
Setting
Set a station address in hexadecimal. If the address
is 28, for example, it corresponds to 1C (h) in
hexadecimal. Therefore, set
STN-H to 1
and
STN-L to C.
Figure 3-1 Station Address Setting
model 3000 ADMAP-5M AN712 Module User's Manual