Toshiba V Series User Manual page 30

Chapter 3 Settings
3
16
Then, check the scan transmission blocks.
Select the [Transmission block] tab on the module parameter screen.
If [Tool (T)] is selected under [Display], one of the scan transmission blocks registered in
Step (1) corresponding to the specified AN712 module is displayed. If [Module (M)] is
selected under [Display], the information registered in the AN712 module is displayed.
(3) Download
The scan transmission blocks and transmission cycles registered using the Tool can be
set in the AN712 module by executing [Download (D)].
Note: Downloaded information will be lost if power is switched off because it is not
retained in the AN712 module. Thus, setting by download should be limited to
system tests, for example. At system product level, therefore, register scan trans-
mission blocks and transmission cycles using communication FB from the con-
troller. For details, refer to Chapters 5 and 6.
model 3000 ADMAP-5M AN712 Module User's Manual