Tool Setting And Operation - Toshiba V Series User Manual

Chapter 3 Settings

3.2 Tool Setting and Operation

3
8
The operating procedures for setting and referring to information using an Engineering
Tool are described.
AN712 module engineering covers the following:
(1) Registering AN712 modules in a station
(2) Setting various functions in AN712 modules and reading them from the modules
For Engineering Tool setting, either directly connect an RS-232C cable to the S3CPU or
connect it via Ethernet.
Note: In setting various function in AN712 modules or reading them from the modules,
direct connection of an RS-232C cable to the S3CPU is not possible. Connection
must be via Ethernet.
Ethernet connection (module
registration, AN712 function
setting, execution, read)
V series model 3000
Engineering Tool
RS-232 connection
(module registration)
Figure 3-3 Engineering Tool Connection
Engineering Tool
Ethernet
ADMAP-5M
model 3000 ADMAP-5M AN712 Module User's Manual