Panasonic DH-3NS1 Operating Instructions Manual page 28

7. 7. Shower Hanger Installation
① Install the Rail Holder so that the Shower
Head height not higher than the unit top.
Make sure the wall level must be same to the Rail
Holder fixing position. If the wall is not at the same
level, please use spacer (not included) to fix the
accessory.
Upper Rail Holder
Shower Head
Lower Rail Holder
④ Tighten the Shower Hanger with
Shower Hanger Knob.
Shower Hanger
Sliding Rail
Shower Hanger Knob
Hole to fix
Top
Shower Head
Bottom
* Shower Hanger will drop off easily
once the knob is loosen.
8. Rain Shower Installation
[DH-3NP2 (with Rain Shower)]
Install the Upper Bracket on the wall at the
①
same height or lower than the Unit top.
Tighten the Upper Bracket with 1 screw.
(Make sure to insert the Wall Plugs
through the screw holes.)
Install the Lower Bracket by tighten Lower
②
Bracket with screws as shown in Figure 1
(make sure to insert the Wall
Plugs through the screw holes).
Lower Bracket position must be
inline with Upper Bracket. The
distance between the Upper Bracket
and Lower Bracket as shown in Figure 2.
Cover the Lower Bracket with the Lower Bracket Cover.
③
Note: Please make sure the Rubber Packing is set at the Lower Bracket Cover
to avoid any damage to the part.
Assemble the Rain Shower Hanger to Lower Shower Pipe by push and hold the
④
Hanger Button.
Release the Hanger Button to fix at desired position.
② Install the Upper Rail Holder on the wall but
not higher than the Unit top.
Tighten the Upper Rail Holder with 1 screw .
Upper Rail Holder
Safe
Health
Hot
Cool C o
Normal Bubble
Max
Beat
PM Level
e-Cycle - Set + e-Hybrid
ELB Test
Push On- Off
ELB Reset Push Up
⑤ Install to the Upper and Lower
Rail Holder with the Grooves of
the Sliding Rail inserted to the
Rail Holder's Notches.
Tighten the Lower Rail Holder
with 1 Screw (Make sure to
insert the Wall Plugs into the
screw hole).
Sliding Rail
Groove
Screw Notch
5 mm
③
Lower Bracket Lower Bracket Cover
Screw
⑥ Cover the Upper and Lower Rail
Holder with the Rail Holder
Covers
Upper Rail Holder
Cover
Lower Rail Holder
Cover
Approximately
30 mm
36.5 mm
Figure 1
Rubber Packing
- 28 -
③ Prepare the Shower Hanger and Sliding Rail,
remove the Shower Hanger Knob by rotating
it (anticlockwise) then install the parts
following the number (1), (2) and (3).
Sliding Rail
(2)
Shower Hanger
Knob
(1)
(3)
⑦ Adjust the Shower Hanger at the
required level and hang the
Shower Head as shown in
diagram below.
Shower Head
Push
Shower Hanger
Tighten the Screw if
Shower Head moves
downward.
①
②
Approximately
743 mm
Figure 2
④
Shower Hanger
Off High
ELB
ELB Test
Push On- Off
ELB Reset
Push Up