Panasonic DH-3NS1 Operating Instructions Manual page 29

Fix the Lower Shower Pipe with Upper Shower Pipe. Make sure the
⑤
3 pieces of Rubber Packing which set at the Upper Shower Pipe not
dislocate to avoid any damage to the part.
⑥ Assemble the Diverter and the Shower Pipe into component as Shown in Figure 3.
(Make sure to place the Rubber Packing between Diverter and Shower Pipe.)
Tighten it by hand firmly.
Install the Diverter to the Lower Bracket and Shower Pipe Holder to the Upper Bracket
⑦
as shown in Figure 4.
Tighten the Diverter and Shower Pipe Holder with the screw using the allen key provided.
⑧
Note: Make sure the wall level is same for Upper Bracket and Lower Bracket fixing position.
If the wall is not same level, please adjust level of the Shower Pipe Holder before
insert to the Upper Bracket before fixing the screw (refer Figure 5).
⑧
Remove Cap C from the Rain Shower Head (make sure there is
⑨
Rubber packing located inside). Fix the Rain Shower to the Shower
Pipe as shown in Figure 6 by turning clockwise.
Tighten it by hand firmly.
Piping Installation procedure:
Place Rubber Packing between Shower Hose B and Main Body.
⑩
Do not use Piping Tape. Tighten it by hand firmly.
Place Rubber Packing between Shower Hose A and Shower Head.
⑪
Be sure to connect the chrome Hose Nut to Shower Head.
Do not use Piping Tape. Tighten it by hand firmly.
Place the Rubber Packing between Shower Hose B
⑫
(connecting with Main Body) and connect to Diverter at front connection.
Do not use Piping Tape. Tighten it by hand firmly.
Place the Rubber Packing between Shower Hose A
⑬
(connecting with Shower Head) and connect to Diverter at back connection.
Do not use Piping Tape. Tighten it by hand firmly.
Note:
Make sure the hose connection is correct as shown in the figure.
The wrong connection can cause no water flow at Shower Head / Rain Shower Head.
⑪
⑫
From Main Body
Adjust up till approximately
15 mm or less.
Shower
Pipe Holder
Shower
Head
Rain
Shower
Shower
Hose A
Water
Inlet
Rubber
Packing A
- 29 -
⑤
Rubber Packing
Shower Pipe
Holder
Wall
Upper
Bracket
Figure 5
⑨
Cap C
(Please remove
before install to
Shower Pipe
Assembly)
Rubber
Packing C
⑩
Main Body
Shower Hose B
⑬
Water
Outlet
From Shower Head
Pipe Hanger
Assembly
Rubber
Packing B
Diverter
Figure 3
⑥
⑦
Diverter
Figure 4
Figure 6
Main Body