Mounting The Intellivue Smart-Hopping Core Ap To A Wall (Fixed Mount) - Philips ITS4843B Installation Manual

Mounting the IntelliVue Smart-hopping Core AP to a Wall (Fixed Mount)

You can mount the IntelliVue Smart-hopping Core Access Point to a wall using the
mounting screws and screw anchors supplied with the AP. We recommend that you
mount the Core AP high on the wall as close to the ceiling as possible.
To mount the 1.4 GHz IntelliVue Smart-hopping Core AP to a wall:
1. Using a 3/16-inch drill bit, drill a pilot hole 0.188 inches (5 mm) in diameter at
the locations shown in Figure 2-5.
2. Tap a supplied plastic screw anchor into each pilot hole until it is flush with the
wall surface.
This step is not necessary if mounting the IntelliVue Smart-hopping Core AP on a
wood surface.
3. Screw a supplied #6 x 1 1/4 inch self-tapping screw into each screw anchor (or
pilot hole) as shown in Figure 2-5.
Tighten each screw until a 1/16-inch (2 mm) gap remains between the screw
head and the mounting surface.
Figure 2-5: Mounting the IntelliVue Smart-hopping 1.4 GHz Core AP to a Wall (Fixed
4. While holding the AP chassis with its antennas pointing down as shown in
Figure 2-5, fit the holes in the back of the AP chassis over the screw heads that
protrude from the wall. Slide the AP chassis down so that the screw heads are
securely in the grooves in the back of the AP chassis.
IntelliVue Smart-hopping 1.4 GHz Access Point Installation Guide
Mounting the IntelliVue Smart-hopping Core AP to a Wall (Fixed Mount)
Units: millimeters
inches
Mount)
2-9