Philips ITS4843B Installation Manual page 49

the Core AP so that the shoulder screw heads are securely in the grooves of the
wall plate.
11. Using a Torx T10 screw driver, secure the Core AP to the wall plate by screwing
the supplied M3 0.5 X 0.6 T-10 Torx Head security screw into the PEM nut in the
wall plate as shown in Figure 2-15. Torque-tighten the screw to 10-inch lbs. Note
that this safety screw is used to prevent the Core AP from sliding out of the wall
plate.
12. Orient the antenna(s) on the Core AP chassis so they bend upward at right
angles to the chassis. Unscrew the collar, rotate the antenna into position, and
then retighten the collar to secure the antenna in place.
13. Replace the tile back onto the ceiling frame structure with the Core AP antennas
hanging down from the ceiling. Wiring connections to the Core AP can be
accessed via the open hole in the tile.
14. Replace other adjacent ceiling tiles if necessary.
IntelliVue Smart-hopping 1.4 GHz Access Point Installation Guide
Mounting the IntelliVue Smart-hopping Core AP Below a Ceiling Tile (Quick Release)
2-23