Specifications - Philips ITS4843B Installation Manual

Chapter 1: Overview

Specifications

Table 1-4: Model ITS4843B, ITS4843C, and ITS4843D (Radiohead) 1.4 GHz Core Access Point
Specification
Physical:
Chassis (only) Dimensions (H x W x L)
Local Antenna (only) Dimensions
Weight with Antenna
Mounting
Environmental:
Operating Temperature
Storage Temperature
Humidity Range (Operating)
Humidity Range (Storage)
Altitude
Electrical:
Power
ITS4843B, RF Power
ITS4843C, RF Power
(High Power AP)
ITS4843D, RF Power
(Radiohead High Power AP)
Power Sensing
RF Diversity
Frequency Diversity
Antenna Type
LED Indicators
Electrical Installation:
1-12
Specifications
30 mm x 204 mm x 243 mm
(1.2 in x 8.0 in x 9.6 in)
160 mm (6.3 inches L) Sleeve Dipole
<.79g (1.8 lb)
Above Ceiling, Below Ceiling, or Wall Mount, Below Ceiling with quick release, or
Wall Mount with bracket
o
0 to +55 C (32 to 131oF)
o
-40 to +60 C (-4 to 140oF)
o
< 95% RH @ 40 C non-condensing
o
< 90% RH @ 60 C
Operating and Storage up to 3048 m (10,000 ft)
48 VDC nominal (44 - 52 VDC), from PoE Unit via Sync Unit) 8 Watts,
287 mA
8.5 dBm +2/-1.5dB (4.5 mW to 11.2 mW) into Antenna load.
12.5 dBm +/-1.5dB (12.6 mW to 25 mW) into Antenna load.
12.5 dBm +/-1.5dB (12.6 mW to 25 mW) into Antenna load.
Auto sensing POE, compliant with 802.3af
Uses Dual Antenna, selects antenna with best signal.
Dynamic, selects RF channels for best signals.
Sleeve Dipole > 10dB over 1395MHz to 1432MHz in 50 Ohms.
Two LEDs for LAN activity, part of LAN RJ-45 connector.
Three LEDs for Radio Activity, Sync, Network status.
Two LEDs on Remote Antenna Ports provide Power and Fault status (part of RA
RJ-45 connector).
Value