4.3 Optional accessories
These baseplates and shelves are sold separately.
Baseplate for RESU13
Use these accessories in a place where the floor may get wet occasionally.
4.4
Checks before installation
There are a few things to check before installing the battery pack to ensure that it has no
defects.
WARNING
If this checking task is required for any reason after the battery packs is fully installed,
make sure that the inverter is turned off while checking the battery pack.
Shelves for RESU13
1. Remove the top cover. Loosen the four
hexsocket screws at each corner of the cover,
and pull it up.
2. Make sure to set the SW select DIP switch to 0011
See Configuring Battery pack on page 36.
NOTE
possible to measure the voltage of the battery
pack only if the SW select DIP switch is set
to 0011
2
Battery Pack Installation
2
21
.