The number of battery packs
1
2
6.1.2 Setting for battery cell type
Make sure that the Cell select DIP switch is set to 00
6.1.3 Settings for CAN bus pins
Only 1st to 5th pins can be used.
CAN_H
CAN_L
4
6.1.4 Setting for terminal resistors
Make sure that the TermRes DIP switch is set to 11
Bit
1
CAN terminal resistor attached
2
Unused
Make sure that the CAN_H rotary switch is set to 4. This switch
indicates which pin is used for CAN high signal by the inverter.
Make sure that the CAN_L rotary switch is set to 5. This switch
indicates which pin is used for CAN low signal by the inverter.
Make sure that the GND rotary switch is set to 2. This switch
indicateswhich pin is used for ground by the inverter.
GND
5
2
On
Value
0011
1
0010
2
.
2
CAN terminal resistor unattached
Unused
Configuration Switches
Setting
.
2
Setting
Off
37