Steps
1. Insert and push the flat-head screwdriver into the slot on the optional module filler to release the optional module filler from
the chassis.
NOTE:
Step one is only applicable for new installation or component upgrade. For replacing an existing component,
follow the procedure from step two.
2. Insert the Serial module into the optional I/O module slot on the chassis.
3. Connect the Serial module cable to the connector on the system board.
4. Replace the two screws to secure the Serial module to the chassis.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
Removing the optional PS/2 keyboard/mouse module
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
About this task
The following image indicates the location of the optional PS/2 keyboard/mouse module and provides a visual representation of
the removal procedure.
To identify the ports and connectors, see the
after working inside your
before working inside your
system board connectors.
computer.
computer.
Removing and installing components
29