Steps
1. Remove the two screws (M3X3) that secure the PS/2 keyboard/mouse module to the chassis.
2. Slide and lift the PS/2 keyboard/mouse module off the chassis.
3. Disconnect the three PS/2 keyboard/mouse module cables from the connectors on the system board.
4. Remove the PS/2 keyboard/mouse module with the cables off the chassis.
Installing the optional PS/2 keyboard/mouse module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the optional PS/2 keyboard/mouse module and provides a visual representation of
the installation procedure.
To identify the ports and connectors, see the
Steps
1. Insert and push the flat-head screwdriver into the slot on the optional module filler to release the optional module filler from
the chassis.
NOTE:
Step one is only applicable for new installation or component upgrade. For replacing an existing component,
follow the procedure from step two.
2. Insert the PS/2 keyboard/mouse module into the optional I/O module slot on the chassis.
3. Connect the three PS/2 keyboard/mouse module cables to the connectors on the system board.
4. Replace the two screws (M3X3) to secure the PS/2 keyboard/mouse module to the chassis.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
30
Removing and installing components
system board connectors.
after working inside your
computer.