Advertisement
Self-cleaning function
1. How to set:
(1) Press function key to enter function setting, then press
up/down key till CL icon flashing, press function key
again, self-cleaning function is successfully set,"CL"icon
stop flashing.
(2) There is remote control receiver in wired controller, self-
cleaning function can also be set by remote controller.
2. How to cancel:
(1) Press function key to enter function setting, then press
up/down key till CL icon flashing, press function key
again, self-cleaning function is successfully canceled.
The indoor unit will quit after executive the self-cleaning
function.
(2) There is remote control receiver in wired controller,
self-cleaning function can also be canceled by remote
controller.
(3) Self-cleaning function will be canceled after pressing
ON/OFF key or mode key; receiving ON/OFF or mode
change signal from remote controller, self-cleaning
function will also be cancelled.
3. If sleep/timer is set, self-cleaning function will not be in the
function cycle list. After self-cleaning function is set, timer/
sleep function will not be in the function cycle list.
23
Advertisement
