Panasonic Easy Wireless Stick Operation Manual page 25

Troubleshooting
Message List
Software
EWSGUIMain
EWSExporter
Downloaded from ManualsNet.com
(cont.)
(cont.)
Message
Remote is being controlled.
Failed to start "Live Mode".
The projector is in STANDBY.Turn
on the projector power .
Easy Wireless Stick is busy.
Invalid entry.
Cannot start EWSGUIMain because
EWSExporter is already started .
Another user is occupying destina-
tion projector .
"Live Mode" is deactivated.
Failed .
Invalid entry.
Cannot start EWSExporter because
EWSGUIMain is already started .
search engine
Countermeasure
The projector is currently under external control by
using the REMOTE IN terminal .
Switch the input to the network by using the panel for
an external control .
Input selection for the projector may have failed. Switch
the input to the network, and then click the [Live] button
again .
Turn on the power of the projector you want to connect
to, perform the search in the Select Access Port screen
again, and then try connecting again .
The Easy Wireless Stick is in a busy state. Wait a while
and then try again .
Enter the 4-digit number for the projector ID.
EWSExporter is already running . End EWSExporter,
and then try again .
Check the following possible causes.
• Check whether live mode has already been started
by another user.
• Check whether the projector style is set to 4-screen
index style . If it is, change the style other than
4-screen index style using the [NETWORK] menu of
the projector .
• If the Easy Wireless Stick is disconnected during live
mode, the next live mode cannot be started for up
to approximately 30 seconds . Wait a while and then
click the [Live] button again.
Check the following possible causes.
• Check whether live mode has been interrupted by
another user .
• Check whether the power of the projector is off .
If the power is off, turn on the power, perform the
search in the Select Access Port screen again, and
then try connecting again .
• Check whether there are other wireless LAN devices
in the vicinity. If there are, turn off any wireless LAN
device that is not needed before use.
Check whether or not the write destination folder is
write protected, or whether or not there is insufficient
space .
Data other than data exported with EWSExporter can-
not be imported. Use EWSExporter to export the nec-
essary data, and then import that data .
EWSGUIMain is already running . End EWSGUIMain,
and then try again .
– 25 –