Husqvarna BG 250 Operator's Manual page 46

4. Push the startup support lever (A) rearward, to lift
the diamond tools from the surface.
D
C
5. Attach the cord (B) of the operator presence control
on to your arm or to your clothing.
6. Make sure that the key (C) of the operator presence
control is in the product.
7. Turn the emergency stop button (D) clockwise
to make sure that the emergency stop button is
disengaged.
8. Hold the handlebar (E) with one hand and push the
start button (F).
9. Make sure that the direction of rotation is correct.
To do a check of the direction of rotation of
Refer to
the motor BG 250 on page 45 .
10. Push the startup support lever forward, to lower the
diamond tools to the surface.
To start the product BG 250Petrol
CAUTION:
time while you operate the product. If you
do not move the product, the surface can
become rough.
1. Start the dust extractor.
2. Connect the dust extractor hose to the product.
To connect a dust extractor on page 42 .
Refer to
46
A
E
F
B
Move the product all the
3. Open the fuel valve.
4. Stay behind the product.
5. Push the startup support lever (A) rearward, to lift
the diamond tools from the surface.
G
H
D
C
6. Attach the cord (B) of the operator presence control
on to your arm or to your clothing.
7. Make sure that the key (C) of the operator presence
control is in the product.
8. Turn the emergency stop button (D) clockwise
to make sure that the emergency stop button is
disengaged.
9. Hold the handlebar (E) with one hand and pull the
throttle control to half (F).
10. Turn the engine start switch (G) to start the engine.
11. If the battery is empty, pull the starter rope handle
(H) to start the engine.
12. Push the startup support lever forward, to lower the
diamond tools to the surface.
13. Pull the throttle control rearward to increase the
operation speed.
A
F
E
B
1802 - 002 - 13.04.2022