Silvercrest SWKS 2200 C1 User Manual And Service Information page 14

SilverCrest SWKS 2200 C1
Cord wrap
There is an integrated cord wrap on the
underside of the base (5). This enables
you to adjust the power cord (7) length to
suit your conditions.
When the kettle is not in use you can
reduce the cord length to a minimum here.

Unwind the power cord (7) underneath the base (5).

Place the base (5) on an even, non-slip and dry surface. Note that the power cord (7) must be
fed through one of the notches provided on the underside of the base (5) to ensure stable
positioning.
WARNING
If the power cord (7) is not fed through one of the notches provided on the
underside of the base (5), the base (5) and kettle (4) will not be stable. The
movement of the boiling water could make the kettle (4) tip over causing severe
damage to property and personal injury!

Open the lid (10) by pressing the lid release button (9).
"Minimum fill level" indicator
The minimum water fill level is 0.5 litres.
This low level is not visible on the outer
water level indicator (3).
A special mark indicating the exact
minimum fill level can therefore be seen
inside the kettle (4) while filling with
water. This mark inside the kettle (4) is
visible when the lid (10) is open.

Fill the kettle (4) with drinking water, at least up to the "MIN 0.5L" mark inside and up to the
"1.7L MAX" mark on the water level indicator (3) and close the lid (10) by pressing it down
until it clicks into place.
12 - English