Chapter 22: Replacing The I/O Board; Procedure - Dell Inspiron 13 7000 Service Manual

NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Topics:
•

Procedure

• Post-requisites
Procedure
1. Place and align the screw holes on the I/O board with the screw hole on the palm-rest assembly and the screw hole on the
keyboard bracket.
2. Replace the two screws (M2x2) that secure the I/O board to the keyboard bracket.
3. Connect the coin-cell battery cable to the I/O board.
4. Slide the I/O-board cable into the connector on the I/O board and close the latch to secure the cable.
5. Adhere the adhesive tape covering the I/O-board cable connector on the I/O board.
38 Replacing the I/O board
Replacing the I/O board
computer. After working inside your computer, follow the instructions in
22
After
www.dell.com/