Automatic Power Off (Ix1600 / Ix1500 / Ix1400 / Ix500 / Ix100 / Sv600 / S1300I) - Fujitsu ScanSnap iX1400 Basic Operation Manual

Automatic Power OFF (iX1600 / iX1500 / iX1400 / iX500 / iX100 /
SV600 / S1300i)
When the ScanSnap is turned on and left unused for the specified time, it will turn itself off
automatically.
HINT
l For iX1600/iX1500/iX1400/iX500/SV600/S1300i, a notification informs you 5 minutes before the
ScanSnap turns off automatically.
l For iX100, a notification appears in the following cases:
- When a USB cable is used for connection, the ScanSnap will turn off automatically five minutes
later.
- When the ScanSnap is powered by the battery, the ScanSnap has turned off automatically.
Turning the ScanSnap back on after the ScanSnap Has Turned off
Automatically
iX1600/iX1500
To turn the ScanSnap back on, perform one of the following operations:
l Press the touch panel of the ScanSnap
l Close the ADF paper chute (cover) and open it again
HINT
To continue using the ScanSnap, reset the time until auto power-off by performing one of the following:
l Load a document in the ScanSnap
l Press the touch panel of the ScanSnap
l Close the ADF paper chute (cover) and open it again
iX1400/iX500/S1300i
To turn the ScanSnap back on, perform one of the following operations:
l Press the [Scan] button on the ScanSnap (this will not start scanning)
l Close the ADF paper chute (cover) and open it again
HINT
To continue using the ScanSnap, reset the time until auto power-off by performing one of the following:
l Load a document in the ScanSnap
l Press the [Scan] button on the ScanSnap
l Close the ADF paper chute (cover) and open it again
iX100
To turn the ScanSnap back on, perform one of the following operations:
l Press the [Scan/Stop] button on the ScanSnap
l Close the feed guide and open it again
100
Turning the ScanSnap On or Off