Cleaning The Inside Of Ix1600 / Ix1500 / Ix1400 - Fujitsu ScanSnap iX1400 Basic Operation Manual

Cleaning the Inside of iX1600 / iX1500 / iX1400

Scanning repeatedly may cause dust and paper dust to accumulate inside the ScanSnap resulting in
a scanning error.
As a guideline, the inside of the ScanSnap should be cleaned every 1,000 sheets scanned. Note
that this guideline varies depending on the types of documents you scan. For instance, it may be
necessary to clean the scanner more frequently when you scan documents on which the toner is not
sufficiently fused.
l Before cleaning the ScanSnap, you must turn off the ScanSnap and unplug
l Do not place internal parts such as the brake roller and the pick roller within
l The glass inside becomes very hot while the ScanSnap is being used.
Do not use aerosol spray or spray that contains alcohol to clean the scanner.
Paper dust and other dust blown up by strong air from the spray may enter the
inside of the scanner which may cause scanner failure or malfunction.
Also note that sparks generated by static electricity may cause a fire.
ATTENTION
l Do not use water or mild detergent to clean the inside of the ScanSnap.
l It may take a long time for Cleaner F1 to dry if an excessive amount is used. Moisten the cloth with
moderate quantity.
Wipe off the cleaner completely to leave no residue on the cleaned parts.
1.
Unplug the power cable of the ScanSnap from the AC outlet.
2.
Remove any documents from the ADF paper chute (cover).
3.
Remove the Receipt Guide if it is attached.
You can remove the Receipt Guide by holding it with one hand and pulling it.
the power cable from the AC outlet. Not doing so may cause fire or electrical
shock.
reach of small children. Doing so may cause injury.
Before you clean the inside of the ScanSnap, you must unplug the power
cable from the AC outlet and leave the ScanSnap for 15 minutes or more.
435
Cleaning iX1600 / iX1500 / iX1400