Fujitsu ScanSnap iX1400 Basic Operation Manual page 439

6.
Clean the feed rollers and the eject rollers with the ScanSnap turned on.
iX1600/iX1500
1. Connect the power cable of the ScanSnap to the AC outlet.
2. Press
3. Press
4. Press [Roller cleaning] to display the [Roller cleaning] screen.
5. Keep pressing the [Run] button to rotate the feed rollers and the eject rollers.
HINT
When you let go of the [Run] button, the feed rollers and the eject rollers stop rotating.
6. Clean the following locations while rotating the rollers.
l Feed roller (× 2)/eject roller (× 2)
Gently wipe the dirt and dust off while taking care not to damage the surface of the
roller.
Make sure that they are cleaned properly because residue on the rollers will affect the
feeding performance.
iX1400
1. Connect the power cable to the AC outlet and press the [Scan] button for three seconds
with the ADF top section open.
in the home screen on the touch panel to display the [Settings] screen.
to display the [Maintenance] screen.
439
Cleaning iX1600 / iX1500 / iX1400
Feed Roller (x2)
Eject Roller (x2)