Table of Contents
Advertisement
4
Install the filter assembly to the unit
CAUTION
Do not put excessive force and deform
the filter assembly.
If the filter assembly is deformed, it will
not be detected by the unit.
"
" will be displayed on the
temperature / humidity monitor, and the
unit will not be able to operate.
Install the pre-filter to the unit
5
Securely plug the tabs of the pre-filter to the matching holes in the unit.
Slide the switch downwards (2 locations) to lock.
Gently pull the pre-filter to make sure it is not out of place.
Plug the tabs of the pre-filter
6
Attach the rear panel to the unit
Plug the tabs (2 locations) of the
upper part of the rear panel to
the matching holes in the unit.
Gently push the bottom sides of
the panel one after another, and
close it securely until it clicks.
Note
When the rear panel cannot be attached properly or "
on the temperature / humidity monitor after the panel is attached
The drive connection part does not
properly engage in some cases.
In this case, remove the rear panel, slowly
turn the drive connection part on the rear
panel about 45 degrees to the left or right,
and then attach the panel.
Set the filter assembly so that you can see the label
(P.E-45)
Tab
Insertion hole
Insert to the hole
" is displayed
Drive connection part
Filter assembly
Slide the switch downward.
Switch
Pre-filter
Rear panel
Continued on next page
Deodorizing filter
E-15
Advertisement
Table of Contents
