Auto Self Clean Unit - Hitachi EP-L110E Instruction Manual

Cleaning

Auto Self Clean Unit

 Clean the auto self clean unit frequently.
1
Check if the operation has stopped, and then unplug the power cord.
When the unit is still operating, press the
2
Remove the rear panel
3
Remove the auto self clean unit and unit cover and discard dust
4
Clean the auto self clean unit
Discard dust, suck dust by lightly tapping the nozzle brush of a vacuum
cleaner, and wipe the unit using a soft cloth.
If the unit is very dirty, remove the brush rotor and wash the unit with water.
4 -1
Remove the brush rotor and wash the unit with water
Pull up the tab on the right side of the brush rotor and
remove the brush rotor.
Remove dirt using a used soft toothbrush or something
similar while rinsing with water.
Thoroughly remove water, wipe any remaining water with a
dry cloth, and dry the unit in a shade (for approximately one
day in a well-ventilated area).
CAUTION
Do not rub the brush nozzle of the vacuum cleaner with
strong force or with a scourer. Doing so may damage the
brush nozzle or scratch the surface.
Do not use detergent.
4 -2
Wash the fixed brush and dust box with water
Wash them with running water.
Thoroughly remove water and let the parts dry in a shade
(approximately one day in a well-ventilated area).
CAUTION
Do not remove the fixed brush and gear of the auto self
clean unit.
Do not scrub them with a brush or sponge because it may
break them or damage their surface.
Do not use detergent.
4 -3
Attach the brush rotor
Pass the left shaft of the brush rotor
through the hole of the dust box.
Press the right shaft of the brush rotor
into the dust box.
Left shaft
Note: The shape of the right and left shafts of the brush rotor is different.
E-38
(Continued)
(P.E-14)
Right shaft
Brush rotor
power button to stop operation.
Brush rotor
Toothbrush
Hole
With the brush surface
facing upward, attach the
brush rotor.
(P.E-36)
Nozzle brush
Auto self clean unit
Tab
Brush rotor
Fixed side of brush
Dust box Gear
Brush rotor