Pm2.5 Sensor; Switching Between Temperature / Humidity Monitor Display; Stopping Operation Using Off-Timer - Hitachi EP-L110E Instruction Manual

Useful Features

PM2.5 Sensor

 Change into a sensor that is suitable for small particles, like PM2.5 (general term for micro particles be-
low 2.5µm). The level of contamination in the air will be detected by the dust sensor, and the unit will op-
erate automatically between "Medium" to "Max" airfl ow rate.
(Odor sensor control will not be performed)
Note
 Operation modes other than "Air Purify" cannot be set.
 While operating in PM2.5 sensing, the air sensor will light up, then enlarge and shrink slowly.
 For the fi rst 90 seconds of operation, the unit will operate in "Max" airfl ow rate (air sensor: red).
 The fl ap direction will be diagonal.
 It will not respond to the switching of sensor sensitivity.

Switching Between Temperature / Humidity Monitor Display

 Temperature / Humidity monitor display alternately shows both temperature and humidity.
Touch
Display
The display will switch between humidity (%) and temperature (°C) each time the button is touched.
Humidity (%)

Stopping Operation Using Off-timer

 Set the off-timer to automatically stop the unit after the set operation time.
Touch
Timer
At each touch the following display will be appear on the display for setting.
No Display
Display
No Display
2hr
4hr
E-24
to switch display.
Temperature (°C)
to set the timer.
2hr 4hr
Setting Description
Not Set
Automatic stop after about 2 hours of operation
Automatic stop after about 4 hours of operation
(Continued)
(P.E-29)