HP Vectra VL6 7 Installation Manual page 18

c905.bk : ch_6.fb4 Page 1 Thursday, October 22, 1998 9:51 AM
Microsoft Windows 95
SR2
Connecting to a Windows NT Server 3.51
Requirements
• HP Vectra with Plug and Play enabled, running Windows 95 SR2.
• 3COM Etherlink 3C905 Ethernet card and drivers disk ver 2.1.
• Vectra VL8 File Name: OEMSETUP.INF Size: 49.3KB Date: 12/1/97
• Vectra VL7 File Name: El90X.SYS Size: 45KB Date: 3/21/97
• Microsoft Windows NT Server 3.51 machine that supports Net BEUI, TCP/
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
• Network Driver Optimization
• Full Duplex
• Boot PROM
• Media Type
Vectra VL8
I/O Base Address FCC0h (PCI)
Interrupt Request 9 (PCI)
Level
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink 3C905 adapter
card into a PCI slot.
2 Connect network cable media to the 3COM 3C905 card.
Connecting to a Windows NT Server 3.51
Microsoft Windows 95 SR2
Normal
Auto Select (N-WAY)
Disabled
Auto Select (N-WAY)
Vectra VL7
FC40h (PCI)
9 (PCI)