HP Vectra VL6 7 Installation Manual page 34

c905.bk : ch_11.fb4 Page 1 Thursday, October 22, 1998 9:51 AM
Windows NT
Workstation Ver. 3.51
Connecting to a Windows NT Server 4.0
Requirements
• HP Vectra with Microsoft Windows NT Workstation 3.51 installed.
• 3COM Etherlink 3C905 ethernet card and drivers disk ver. 2.1.
• Vectra VL8 Driver Name: DRMONNT.INF Size: 16KB Date: 1/23/98
• Vectra VL7 Driver Name: OMESETUP.INF Size: 41K Date: 3/14/97
• Microsoft Windows NT Workstation 3.51 and Service Pack Media.
• Microsoft Windows NT Server 4.0 machine that supports Net BEUI, TCP/
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
• Network Driver Optimization
• Full Duplex
• Boot PROM
• Media Type
Vectra VL8
I/O Base Address FCC0h (PCI)
Interrupt Request 9 (PCI)
Level
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink 3C905 adapter
card into a PCI slot.
Connecting to a Windows NT Server 4.0
Windows NT Workstation Ver. 3.51
Normal
Auto Select (N-WAY)
Disabled
Auto Select (N-WAY)
Vectra VL7
FC40h (PCI)
9 (PCI)