HP Vectra VL6 7 Installation Manual page 37

c905.bk : ch_12.fb4 Page 1 Thursday, October 22, 1998 9:51 AM
Windows NT
Workstation 4.0
Connecting to a Windows NT Server 4.0
Requirements
• HP Vectra with Windows NT Workstation 4.0 Service Pack 3.
• 3COM Etherlink 3C905 Ethernet card and drivers disk ver 2.1.
• Vectra VL8 Driver Name: 3C90X.SYS Size: 74KB Date: 1/09/98
• Vectra VL7 Driver Name: 3C90X.INF Size: 71KB Date: 11/25/96
• Microsoft Windows NT Workstation 4.0 and Service Pack Media. (If you
have a Hewlett-Packard pre-loaded HDD, the media is located at
"C:\I386")
• Microsoft Windows NT Server 4.0 machine that supports Net BEUI, TCP/
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
Device Configuration
• Network Driver Optimization
• Full Duplex
• Boot PROM
• Media Type
Vectra VL8
I/O Base Address FCC0h (PCI)
Interrupt Request 9 (PCI)
Level
Procedure
1 With the HP Vectra turned off, install the 3COM Etherlink 3C905 PCI
Connecting to a Windows NT Server 4.0
Windows NT Workstation 4.0
Normal
Auto Select (N-WAY)
Disabled
Auto Select (N-WAY)
Vectra VL7
FCC0h (PCI)
9 (PCI)