JVC SW-D8000U Instruction Manual page 38

SW-D8000U, 16CH. COLOR VIDEO MULTIPLEXER
The Normal Record Speed can be programmed here in the OPERATORS menu. The factory
default settings are 2 hours. The Normal Record Speed menu appears as follows;
The selection of either 'Fields' or 'Hours' will cause the other to change accordingly. Typically
the Hour setting will be used, however it may be necessary to use the 'Field' setting dependent
on the VCR used. Refer to your VCR's recommendations for field delay time to properly set
this option.
Indicator:
During recording, the SW-D8000U indicates the speed at which it is recording on Monitor-A. It
uses the same time-format for the indicator as is generally used by time lapse VCRs. For
example, R024 will be displayed to indicate that the unit is recording in 24-hour mode. (If the
VCR switch input is active, then R EXT will be displayed.
Checking record output settings (VCR VIEW): The operator may need to view the video output
of the VCR, typically this is to check VCR output or settings.
To select the VCR as input, press
On Monitor-A you will see the multiplexed video images as they are being
output to the VCR for recording.
To de-select the input, repeat the above procedure. Notice that when VCR VIEW is exited, the
unit always reverts to Live mode.
VCR Playback Speed:
The programmer must select the Playback speed on the VCR, and not on the SW-D8000U.
There is no related setup required on the SW-D8000U during Playback.
The SW-D8000U will automatically adjust its display to match the VCR Playback speed.
Indicators:
During Play mode the on-screen text "P" indicates the current mode, Play mode. The speed at
which the data was recorded is displayed after the "P".
example 24 hour mode) tells the operator the speed at which the tape was recorded. It does
not indicate the speed at which the tape is being played back. To find out the Playback speed,
the operator must look at the VCR's Playback speed indicator.
If the recording was made using the camera switch VEXT input, then the mode and speed
indicator will read 'P EXT' in Play mode.
The time and date is displayed on-screen during Play mode. Note that this is the recorded
time, not the current system time.
The indicator 'V' will be displayed in the corresponding camera image if there was video loss at
the time that the recording was made.
38 JVC PROFESSIONAL, IMAGING PRODUCTS
Normal Record Speed
Fields Hours
[001] [002]
FUNCTION
(F) and then press
PLAY
.
The on-screen "P024" indicator (for