Table of Contents
Advertisement
SW-D8000U, 16CH. COLOR VIDEO MULTIPLEXER
This prompts the user to use
the
ALARM
setup action mode.
q
NO ACTION - used to move the cursor around the grid to zones that
must be changed to enabled or disabled. After selecting NO ACTION
mode by using the ALARM key, use the ARROW keys, to go to the
first zone to be changed.
q
ENABLE ZONES - is used to change disabled zones to enabled zones.
Enabled zones will sense motion, according to SETUP PARAMETERS. After
selecting ENABLE ZONES mode by using the ALARM key, the flashing cursor
will be changed to the enabled mode (black/white flashing).
ZONES is selected, the ARROW keys move the cursor and enable adjacent
zones. Change the mode to NO ACTION or DISABLE ZONES when no more
adjacent zones need to be enabled.
q
DISABLE ZONES - is used to change enabled zones to disabled zones. Zones
which are disabled will ignore all motion. After selecting DISABLE ZONES mode
by using the ALARM key the flashing cursor will be changed to the disabled
mode (clear/white flashing). Once DISABLE ZONES is selected, use the
ARROW to move the cursor and disable adjacent zones as necessary.
Change the mode to NO ACTION or ENABLE ZONES when no more adjacent
zones need to be changed.
Indications:
To indicate whether each zone is enabled or disabled, enabled zones have a grey " " indication
and disabled zones have a clear indication inside the corresponding grid position.
Sensitivity Scope
Your multiplexer includes a helpful graphic representation of motion and the sensitivity settings to
simplify motion detection set-up. You will find a "Sensitivity Scope" on the left side lower portion of
the image. This scope represents the sensitivity setting you have selected in RED. A BLACK line
that will move from bottom to top of the scope when movement occurs represents the actual
motion/activity in the scene. When the BLACK line intersects with the RED line, a motion alarm is
activated. In this mode, the sensitivity can be changed by selecting the number keys 1-10. In this
way, the actual motion in the scene can be used to set the most appropriate sensitivity setting.
Exit SETUP ACTIVE ZONES:
When all zones have been set up, the programmer can exit back to the MOTION
DETECTION sub-menu. Press ENTER and all changes will be saved as they were
made.
INDICATE DETECTION
JVC PROFESSIONAL, IMAGING PRODUCTS
key to toggle the
ALM: NO ACTION
ENTER TO EXIT
This prompts the user to use the
key to
this menu.
ENTER
EXIT
This shows the
selected setup mode.
Once ENABLE
59
Advertisement
Table of Contents
