Table of Contents
Advertisement
E-4
2.2. Adapter installation/removal
2.2.3. Before Installation
If you have already used another graphics accelerator
If you are using a graphics accelerator other than this product, please uninstall the existing graphics accelerator
display driver before installing the driver for this product.
Changing BIOS settings
After installing this board in the server, it is necessary to change the BIOS settings of the server before and after
installing the driver.
Start the server, press the F2 key during POST startup to launch BIOS Setup, and change the following settings.
BIOS Menu → Advanced → PCI Subsystem
■Before installing the driver
[Onboard VGA Controller]
■After installing the driver
[Onboard VGA Controller]
After changing, save the settings with [Save Changes and Exit] and turn off the system power.
In the case of built-in shipment (Build To Order; BTO)
Even if you purchase this product by built-in shipment, please be aware that it will be necessary to install the
display driver.
If you hear a beep when powering on, this product is not recognized correctly. In that case,
NOTE:
make sure that the card is completely inserted into the PCI-Express slot.
Enabled
Disabled
Advertisement
Table of Contents
