Store & Recall; How To Recall Arb Waveforms - HP 3314A Operating Manual

The 3314A has 12 Waveforms storage registers, six for non
for ARB waveforms.
rent front panel settings at power off; registers 1 through
The ARB registers 0
of all 12 registers, stored in
ed off.
How to Store and Recall Front Panel Settings
You can store the current (non-ARB) settings using the STO key followed by one
of the keys in the top row of the Entry key group. The register number where the
settings will be stored are located to the upper right of each key. To recall a front
panel, use the RCl key followed by one of the Entry keys. RCl 0 will recall the
front panel setting when the 3314A last lost power or was turned Off. Note that
if a series of power failures occurs, you will still be able to recover the last front
panel setting you used.

How to Recall ARB Waveforms

There are 6 ARB waveforms stored in the 3314A. The wave parameters are
stored into the proper ARB register as the waveform is created. There is no key or
command to store an ARB waveform. To recall a waveform, use the RCL and ARB
keys, followed by one of the keys in the ·Ent ry Group. The number to the upper
right of each key indicates the ARB wave that will be recalled. The 3314A will
display • Arx· for 1/2 second to indicate which ARB wave was recalled.
STORE
For non-ARB waveforms
through 5 store waveforms as they are built in them. The contents
non-volatile
&
RECALL
, register 0 automatically ret ains the
5
are reserved for the
memory are retained whenever power is turn-
78a
-ARB waveforms and six
operator.
cur-