Huawei AP4030DN
Hardware Installation and Maintenance Guide
2.4 Determining the Installation Position
When determining the AP installation position, comply with the following rules:
Figure 2-2
Figure 2-2 Dimensions of an AP4030DN (unit: mm)
2.5 Installing the AP
2.5.1 Wall Mounting
Mounting APs on a wall requires sheet metal mounting brackets and expansion screws. The
procedures are as follows:
1.
Issue 02 (2015-05-18)
Try to reduce the number of obstacles, such as walls, between the AP and user terminals.
Install the AP away from electronic devices that can cause radio interference, such as the
microwave oven.
Install the AP in a hidden position that does not affect daily lives and work of residents.
Install the AP in a site that is free from leaking or dripping water, heavy dew, and
humidity, and take protective measures to prevent water from flowing into the equipment
along the cable.
Indoor APs are usually mounted on a wall or ceiling using sheet metal mounting brackets.
The installation position is determined by the site survey. Leave at least 200 mm of
clearance around the device.
shows dimensions of the AP4030DN.
If the AP surface is covered with protective film, remove it before installation.
Fix the mounting bracket to the wall, adjust the installation position, and use the marker
to mark the drilling positions where expansion screws are installed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 AP Installation
9