Huawei AP4030DN Hardware Installation And Maintenance Manual page 47

Hide thumbs Also See for AP4030DN:

Table of Contents

Huawei AP4030DN

Hardware Installation and Maintenance Guide

Figure 5-35 Dirt on a contract strip

Step 4 Check whether the contact strips and the plastic separators are well aligned and intact. If a

separator is skew and cannot be fixed, replace it with a new RJ45 connector.

shows an unqualified piece.

Figure 5-36 Skew plastic separators

Step 5 Hold the connector with the side facing towards you, and check whether you can see the

cross-sections of the wires. Ensure that the ends of the wires are in good contact with the edge

of the RJ45, and that the contact strip blade extends beyond the ends of the wires and is

crimped with the wires. If not, replace the connector.

Figure 5-37 Wires not in good contact with the edge of the RJ45

----End

Issue 02 (2015-05-18)

Huawei Proprietary and Confidential

Figure 5-36

Figure 5-37

shows an unqualified piece.

5 Appendix

Table of Contents